Installation Instructions
Method 3: Housing unit with internal height 710mm or more
Note: You will not need the 4 runners and 2 trims that are packed with the oven for this installation.
Remove any fixings that may prevent entry of the oven into housing, or obstruct the gas inlet pipe. The cabinetry should be kept structurally sound by fixing to adjacent cabinets, floor or worktop.
|
| |
547mm |
| min 550mm |
|
| |
9mm |
| min |
703mm |
| |
| 710 | |
|
| |
706 | 697 | mm |
mm |
| |
mm | 12mm gap in | |
| ||
595mm | plinth for air intake | |
|
| |
550mm |
| |
1.When installed in a typical 600mm deep built in housing unit, the false back should be removed from the housing unit to provide the necessary depth for installation.
2.When the false back is removed, it is normally the case that the support shelf for the appliance leaves a gap between the back edge and the wall of approximately 80mm.
3.If no gap occurs between the back edge of the shelf and the wall behind the unit, you must create a gap of at least 30mm by shortening the shelf.
Worktop | ||
space behind | ||
appliance to | ||
be kept clear | ||
12mm air | support | |
gap in top | ||
shelf | ||
of plinth | ||
| ||
Rear wall
32
