INSTALLATION INSTRUCTIONS
Step 1: Prepare installation
Do not lift the oven by the door handle.
Whilst every care is taken to eliminate burrs and raw edges from this product, please take care when handling - we recommend the use of protective gloves during installation.
Please note that the weight of this appliance is approximately 47kg (unpacked). Take care when lifting it into the housing unit - always use an appropriate method of lifting.
If this appliance is to be installed near to a corner where the adjacen t cabinets run at right angles forward of the appliance, there must be a gap of at least 90mm between the appliance and the cabinets, to prevent overheating of the cabinets.
1.Remove the fixing screws from the polythene bag on the top of the appliance, but leave the appliance in the base tray packaging until you are ready to install it.
Note: When removing the applianc e from the base tray packaging care should be taken to ensure the outer frame trim is not damaged.
2.(i) When installed in a typical 600mm deep built in housing unit, the false back should be removed from the housing unit, to provide the necessary depth for installation.
(ii)When the false back is removed, it is normally the case that the support shelf for the appliance leaves a gap between the back edge and the wall of approximately 80mm.
(iii)If no gap occurs between the back edge of the shelf and the wall behind the unit, we recommend that a gap of at least 30mm is made by shortening the shelf.
3.The appliance is designed to fit into a standard 600mm wide housing unit, with minimum internal
dimensions as shown on page 22. Please note that all sizes are nominal, some variation is to be expected.
21
