Installation Instructions
Step 2: Connect to the electricity supply
Warning: This appliance must be earthed.
The appliance must be installed by a competent electrician using a double pole control unit of 30 ampere minimum capacity with 3mm minimum contact separation at all poles.
We recommend that the appliance is connected by a qualified electrician who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulation.
1.Access to the mains terminal is gained by opening the terminal block cover at the rear of the appliance (use a small
2.Connection should be made with suitable twin and earth heat resistant flexible cable, minimum 4mm2, which is suitable for use up to 25 amps.
3.First strip the wires, then push the cable through the cable clamp in the terminal block cover.
4.Connect the cable to the terminal block and tighten the cable clamp cover.
5.Close the terminal box, ensuring that the cover is engaged on the locking tabs.
Step 3: Secure appliance into housing unit
Insert appliance into cabinet.
Note: The unit housing the appliance must be appropriately fixed.
To secure applianceto housing unit
Note: Ensure that the appliance is centrally located.
Take care not to damage the appliance or cabinet.
There are 6 securing screws.
•Open the grill / top oven door, and screw 2 screws through the top corner holes in the front frame.
•With the grill / top oven door still open, screw 2 screws through the holes in the front frame, located under the grill compartment.
Close the grill / top oven door.
•Open the main oven door, and screw the remaining 2 screws through the bottom corner holes in the front frame.
Close the main oven door.
23
