•Replace damaged cutting wheel before operating.
•Do not fill water compartment above water fill line.
•Ensure that the directional arrow marked on the blade corresponds with the rotational direction of the motor.
•With the machine disconnected from the power supply, rotate the blade by hand to ensure it is free from obstruction.
•Always keep the
•Ensure that the
•Never try to cut freehand. Always ensure that the tile to be cut is pressed firmly against the rip fence.
•Ensure that the piece of tile that will be cut off has sufficient room to move sideways. Failure to do so may result in the off cut binding against the blade.
•Never cut more than one tile at a time.
•Never cut pieces too small to be held securely against the rip fence without leaving enough space for the hand to be a safe distance from the blade.
•Ensure that the table and surrounding area are clear with the exception of the tile to be cut.
•Before cutting a piece of tile let the saw blade run freely for a few seconds. If it makes an unfamiliar sound or vibrates excessively switch it off immediately and disconnect from the power supply.
•Let the blade reach full speed before starting the cut.
•Let the blade come to a complete stop before removing any jammed or off cut material from around the blade area.
•Never allow the blade to run dry. Failure to keep the water compartment topped up will result in possible
Position of tile saw | Tool |
Supporting Surface |
1.To avoid the possibility of the appliance plug
or receptacle getting wet, position tile saw
to one side of a wall mounted receptacle
to prevent water from dripping onto the
receptacle or plug. The user should arrange a “drip loop” in the cord connecting the saw to a receptacle. The “drip loop” is that part of the cord below the level of the receptacle, or the connector if an extension cord is used, to prevent water travelling along the cord and coming in contact with the receptacle.
2.If water is present have an electrician complete any necessary work or repairs. DO NOT ATTEMPT ANY REPAIRS YOURSELF.
Accessories
The GMC LSTSAW tile cutting saw is supplied with the following accessories as standard:
•Rip fence
•Mitre gauge
•Laser light assembly
•Laser light arm
•Laser light arm locking knob
•Face spanners x2
•AAA batteries x2
•180mm Diamond Blade (Fitted)
•Instruction manual
•Receipt holder
6
