move the assembly to the left or right until the laser line is in line with the blade.
5. Tighten the laser light assembly locking knob.
Changing the batteries
1.Remove the laser light assembly (21) from the laser light arm (19).
2.Slide off the laser light battery cover (23).
3.Replace both AAA batteries, taking care to insert the new batteries
with the correct polarity.
WARNINGS. Use only correct batteries, 2 x AAA
DO NOT mix old and new batteries
DO NOT mix alkaline, standard
4. Replace the laser light battery cover.
CAUTION. Remove the laser light batteries when the tool is to be stored without use for a few days or more. If left in position, the batteries might leak and damage the laser light assembly. Damage due to leaking batteries is not covered under warranty.
Maintenance
WARNING. Always ensure that the tool is switched off and the plug is removed from the power point before making and adjustments or maintenance procedures.
When you have finished cutting your tiles, always disconnect the power, empty the water and fully clean and dry the machine.
Cleaning
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with a soft brush or a rag.
3.
4.Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic parts of the saw. A mild detergent on a damp cloth is recommended.
General inspection
Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Repairs
Only an authorised service centre should replace the cordset or effect other repairs. If the cordset is damaged or worn, have it repaired or replaced by an authorised service centre.
14
