d)Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e)Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f)Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
g)Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation.
4) Service
a)Have your power tool serviced by a qualified repair personnel using only identical replacement parts. This will ensure that the safety of the power tool
is maintained.
Additional safety rules for petrol brush cutters
•Do not operate in a hazardous location. Such areas include where there is a risk of explosion of petrol fumes, leaking gas or explosive dust.
•Do not operate in a confined area. Exhaust gases, smoke or fumes could reach dangerous concentrations.
•Protect your tool. This brush cutter is NOT WEATHERPROOF and should not be exposed to direct sunlight, high ambient temperature and damp, wet or high humidity conditions.
•Do not smoke while refuelling. This is potentially dangerous as it may ignite the fuel and cause an explosion.
•Take care not to spill fuel. When refuelling the brush cutter ensure that the motor has been switched off. Prevent the spilling of fuel as this may also ignite on the hot motor. Never refuel whilst the engine is running.
•Be careful where you store the brush cutter. Store the brush cutter in a dry area away from flammable liquids.
•Keep your distance. The brush cutter emits exhaust fumes. Ensure bystanders keep a safe distance.
•Ensure you use
•Never fill fuel tank indoors. Never fill fuel tank when engine is running or hot. Do not smoke when filling the fuel tank.
Unpacking
Due to modern mass production techniques, it is unlikely that your petrol brush cutter is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Contents of carton
•Upper shaft with motor
•Lower shaft
•Secondary handle (two sections) with 2 screws and nuts
•Safety guard to suit the blade
•Safety guard to suit the spool head
•Spool head
•3 Tooth blade
•4 Bolts to attach the safety guards
•Cutting head assembly cover
•Outer flange
•Blade retaining nut
•Split pin
•Spark plug wrench
•Carry strap
•Locking pin
5
