11. Loosen the Phillips head screw holding the pointer f of the mitre scale (22)
and adjust it so that it accurately indicates the zero position on the mitre scale (fig. f).
12.Retighten the screw securing the mitre scale pointer.
13.Replace the top section of the fence and secure the hex screw using the 6mm hex key.
Changing a blade
DANGER! Never try to use a blade larger than the stated capacity of the saw. It might come into contact with the blade guards. Never use a blade that is too thick to allow the outer blade washer to engage with the flats on the spindle. It will prevent the blade screw from properly securing the blade on the spindle. Do not use the saw to cut metal or masonry. Ensure that any spacers and spindle rings that may be required suit the spindle and the blade fitted.
1.Make sure that the electrical plug is removed from the power point.
2.Push down on the
operating handle (7) and g
pull the release knob (6) to disengage the saw arm
(5). The release knob (6) can be turned so that it is held in the retracted position (fig. g).
3.Raise the saw arm (5) to its highest position.
4.Using a Phillips head screwdriver loosen and remove the screw that secures the guard retraction arm (13) to the rotating blade guard (fig h).
5.Using a Phillips head screwdriver loosen (fig. i) and remove the screw that secures the blade bolt cover (14).
6.Pull the rotating blade guard (12) down then swing it up together with the blade bolt cover (14). When the rotating blade guard (12) is positioned over the upper fixed blade guard (9) it is possible to access the blade bolt (fig. j).
h
i
j
15
