Up and press, Blade fig. m | Global Machinery Company DB250SMS

7. Hold the rotating guard
7. Hold the rotating guard		k
(12) up and press the		k
spindle lock button (26)
(fig. k). Rotate the blade
until the spindle locks.
8. Use the 6mm hex key
provided to loosen and
remove the blade bolt.
(Loosen in a clockwise
direction as the blade
screw has a left hand
screw has a left hand		l
thread) (fig. l).		l
9. Remove the flat washer
and outer blade washer
and the blade.
10. Wipe a drop of oil onto
the inner blade washer
and the outer blade
washer where they
contact the blade.
11. Fit the new blade onto
11. Fit the new blade onto		m
the spindle taking care		m
that the inner blade
washer sits behind the
blade (fig. m).

CAUTION. To ensure correct blade rotation, always install the blade with the blade teeth and the arrow printed on the side of the blade

pointing down. The direction of blade rotation is also stamped with an arrow on the upper blade guard.

12.Replace the outer blade washer (fig. n).

13.Depress the spindle lock button (26) and replace the flat washer and blade bolt.

14.Use the 6mm hex key to tighten the blade bolt securely (tighten in an anti-clockwise direction).

15.Lower the blade guard, hold the rotating lower blade guard (12) and blade bolt cover (14) in position and tighten the fixing screw (fig. o).

16.Replace the guard retraction arm and secure onto the rotating blade guard (fig p).

17.Check that the blade guard operates correctly and covers the blade as the saw arm is lowered.

18.Connect the saw to the power supply and run the blade to make certain that it is operating correctly.

n

o

p

16

Image 16

Global Machinery Company DB250SMS Up and press, Direction as the blade Screw has a left hand Thread fig. l, Blade fig. m

Contents

Double Bevel Slide Compound Mitre Saw Contents Description of symbols SpecificationsDear Customer Introduction General safety instructions Safety rules for laser lightsDamage to hearing if effective earmuffs are not worn Page Additional safety rules for mitre saws Wear gloves when handling saw blades and rough materials Take additional care when trenching slottingEnsure that the arm is properly secure when bevelling Select saw blades in relation to the material being cut Accessories Know your product Unpacking TransportationBench mounting Stabiliser bar Bevel adjuster Clamp assemblySlide lock Mitre table lock Rotating lower Blade guard Spindle lock buttonDust bag Setting the table Switch 24 fig. STurning on and off Turning on Redeye laser line Generator Setting the fence Square with the table To the base fig. dTighten the screws securing the fence Retighten the bevel lock Retighten the screw securing the mitre scale pointer Changing a bladeRaise the saw arm 5 to its highest position Outer blade Washer where they Contact the blade Up and pressDirection as the blade Screw has a left hand Thread fig. l That the inner blade Cross-cutting without slide action Across the grainMade with the mitre table Set at 0º fig. q. Mitre By loosening the clamp Cross-cutting With slide action Bevel cutBevel cut is made by Angled to the fence Adjusting the laser lines Compound mitre cut Do not stare directly at the y laser beam Using the laser line generatorTowards the eye of a person for longer than 0.25s Cleaning Maintenance Power cord maintenanceGeneral inspection Page Page Save this Manual for future reference