Using the laser line generator

WARNINGS

Do not stare directly at the y laser beam.

Never aim the beam at any person or an object other than the workpiece.

Do not deliberately aim the beam at personnel and ensure that it is not directed

towards the eye of a person for longer than 0.25s.

Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces. Wood or rough coated surfaces are acceptable. Bright shiny reflective surfaces are not suitable for laser use as the reflective surface could direct the beam back at the operator.

Always remember to switch off the laser on/off switch (2) after finishing a job. Only turn the laser beam on when the workpiece is on the mitre saw table.

1.Mark the line of the cut on the workpiece.

2.Adjust the angle of mitre and bevel of the cut as required.

3.Switch on the laser light on/off switch (2).

4.Clamp the workpiece in position using the laser lines to align the blade with the pencil mark on the workpiece.

NOTE. To cut to the left-hand side of the blade, align the left-hand laser line with the pencil mark. To cut to the right-hand side of the blade, align the right-hand laser line with the pencil mark.

5.Plug in the machine and start the motor.

6.Press the release latch (36).

7.When the blade is at its maximum speed (approximately 2 seconds), lower the blade through the workpiece.

8.After completing the cut, switch off the laser light on/ off switch (2).

9.After each use, clean the laser light assembly (1) as described below:

Switch off the laser light switch (2) and then remove the plug from the power point.

With the saw arm (5) in the raised position, use a soft brush to dust away the sawdust build-up around the assembly.

NOTE. Wear eye protection whilst brushing the dust away.

20

Page 20
Image 20
Global Machinery Company DB250SMS, DB305SMS Using the laser line generator, Do not stare directly at the y laser beam