Gear selector
The gear selector (10) allows you to shift gears for greater versatility of operation.
1.To select the low speed, high torque setting (Position 1), turn the tool off and let the motor come to a complete standstill. Turn the gear selector to Position “1”.
2.To select the high speed, low torque setting, (Position 2), turn the tool off and let the motor come to a complete standstill. Turn the gear selector to Position “2”.
NOTE. Do not change gears when the drill motor is turning.
If you are having trouble changing gears, make sure that the gear selector is either completely in Position 1 or completely in Position 2 as you rotate the chuck by hand.
Chuck replacement
Always wear eye protection.
Chuck removal
The chucks of reversible drills are always fixed by a screw with
1.Tighten the chuck around the shorter end of a hex key (not supplied) of 1/4” or greater size. Using a wooden mallet or similar object, strike the longer end in the clockwise direction. This will loosen the screw inside the chuck.
2.Open chuck jaws fully.
3.Insert a screwdriver into front of chuck between jaws to engage screw head. Remove screw by turning clockwise.
4.Place a hex key in chuck and tighten. Using a wooden mallet or
similar object, strike key sharply in the counterclockwise direction. This will loosen the chuck so that it can be unscrewed by hand.
Chuck installation
1.Screw the chuck on by hand as far as it will go and insert screw (LH thread).
2.Tighten the chuck around the shorter end
of a 1/4” or large hex key (not supplied) strike the longer end in the clockwise direction with a wooden mallet.
3.Remove the hex key and open the jaws fully. Tighten the screw in the centre of the chuck firmly.
10
