mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ

6. System Setup

Power Up and Status Check

mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ

 

FSN Series system setup: Step 1.

1

„ Use the following steps to power up your system and check system status.

S Prerequisite — Ensure that your system is properly installed and cabled. In

 

Chapter 4, refer to the following sections for details:

 

~ Control Panel Installation,” page 106.

 

~ Touch Screen Installation,” page 107.

 

~ FSN-1400 System Connections,” page 112.

 

S Prerequisite — Ensure that you are familiar with the System Menu. In

 

Chapter 5, refer to the “System Menu Description” section on page 189 for

 

complete details.

1. Power up the FSN-1400.

2. Power up the FSN-150 control panel. The System Menu is automatically displayed after boot up.

Important

If communication is not properly set up, numerous buttons will be grayed out on the System Menu. These buttons will activate once communication is properly set.

3.Power up all additional peripherals, such as monitors and sources.

4.On the System Menu:

~In the System Status Table, ensure that all devices are connected. If not, re-check all Ethernet connections. After checking connections, if devices still report “Not Connected,” use the “Communications Setup” procedure on page 285.

~Ensure that the software versions for the control panel and FSN-1400 match. If not, you may need to update control panel software or match the FSN-1400’s software to the installed control panel software. Refer to Chapter 10, Updating Software” on page 425 for details.

Note

If the software versions on the control panel and FSN-1400 match, you do not need to upgrade.

~In the FSN-1400 Status Table, ensure that all installed NIC, UIC, NAC and DVE cards are recognized. If not, you may need to re-seat the boards in the FSN-1400.

282

 

FSN Series • User’s Guide • Rev 01

 

Page 282
Image 282
Barco 26-0702000-00 mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ, ~ “Control Panel Installation,” page, ~ “Touch Screen Installation,” page