Barco 26-0702000-00 manual j~åì~ä=jáñ=hÉó, ìíçã~íáÅ=jáñ=hÉó, j~åì~ä=táéÉ=hÉó, Press AUTO TRAN

7. Operations

Working with Keys

j~åì~ä=jáñ=hÉó

„Use the following steps to perform a manual mix key:

1.Ensure that the key(s) you wish to transition are properly set up. Refer to the “Key Setup” section for details.

2.In the Next Transition Group, select the layers that you wish to transition:

~On the M/E, enable KEY 1 and/or KEY 2 as desired. If you want the background to transition along with the selected key, enable BG.

~On the PGM bank, enable DSK. If you want the background to transition along with the DSK, enable BG.

3.Use the T-Barto perform the manual mix key. The selected key(s) will transition up or down, depending on their current state.

^ìíçã~íáÅ=jáñ=hÉó

„Use the following steps to perform an automatic mix key:

1.Ensure that the key(s) you wish to transition are properly set up. Refer to the “Key Setup” section for details.

2.In the Next Transition Group, select the layers that you wish to transition:

~On the M/E, enable KEY 1 and/or KEY 2 as desired. If you want the background to transition along with the selected key, enable BG.

~On the PGM bank, enable DSK. If you want the background to transition along with the DSK, enable BG.

3.Press AUTO TRAN.

Please note the following important points regarding automatic mix keys:

•You can also press ALL TRAN (in the Custom Control Section) to perform the transition on all buses simultaneously.

•Remember that there are a wide variety of auto-transition combinations available. Refer to the “Automatic Transitions” section on page 325 for details.

j~åì~ä=táéÉ=hÉó

„Use the following steps to perform a manual wipe key:

1.Ensure that the key(s) you wish to transition are properly set up. Refer to the “Key Setup” section for details.

2.In the Next Transition Group, select the layers that you wish to transition:

~On the M/E, enable KEY 1 and/or KEY 2 as desired. If you want the background to transition along with the selected key, enable BG.

~On the PGM bank, enable DSK. If you want the background to transition along with the DSK, enable BG.

3.On the Wipe Menu, select the desired pattern, direction, edge type, edge width, and edge color (if a Hard Edge wipe is selected).

4.Use the T-Barto perform the manual wipe key. The selected key(s) will transition up or down, depending on their current state.

FSN Series • User’s Guide • Rev 01 335