Barco 26-0702000-00 manual System Setup, FSN Series • User’s Guide • Rev

6. System Setup

Aux Setup

8.For interlaced Aux outputs only, press {De-Interlace}to display the De-InterlacePop-up. Select Motion Adaptive or Field to Frame as required.

9.If Motion Adaptive is selected, press {Motion Threshold} and use the control to adjust the threshold of the motion adaptive de-interlacer.

10.Press {DVI Sync}, and select the desired polarity of the digital sync output on the DVI connector.

11.Press {Analog Type}, and select the desired type of analog sync output on the HD-15 connector.

12.If {HV Sync} is selected on the {Analog Type} button, press {Analog Sync} and select the desired polarity of the analog sync output on the HD-15 connector.

13.If you want to copy settings to another UOC channel, press {Copy All Settings}. In the Copy Settings Keypad, select the desired channel, and press {Copy} to complete the process.

14.If you want to set the channel’s settings to their default value, press {Restore Default Settings}.

15.Press {Back} to return to the Aux Setup Menu. Repeat from step 1 to set up additional Aux outputs.

„Advanced Setup — Use the following steps to set advanced UOC output parameters:

1.On the Output and Process Panel, press {Advanced Output Setup} to display the Advanced UOC Setup Menu.

Caution

The Advanced UOC Setup Menu is designed for advanced users who are familiar with all aspects of output timing adjustments. Do not use this menu if you are uncertain about any output timing parameter.

2.On the Advanced UOC Setup Menu, press the UOC Aux connector that you want to set up.

3.Press {Totals}, and use the {H Total} and {V Total} controls to set the total number of horizontal pixels and vertical lines in the output.

Important

Changing the H and V Totals will cause a disruption to the UOC’s output video. Press {Apply} to apply changes, or {Undo} to reverse un-applied changes.

4.Press {Active and Pos}, and use the {H Pos}, {V Pos}, {H Active} and {V Active} controls to set the output’s H and V active area, and the H and V position.

5.Press {Sync}, and use the {H Sync} and {V Sync} controls to adjust the output’s horizontal and vertical sync pulse width.

6.If the selected UOC output format is vertically locked to the native resolution’s vertical sync, press {Offset Timing}. Use the {H Offset} and {V Offset} controls to adjust the UOC output’s video timing relative to the system’s native resolution.

7.Press {Back} to return to the Output and Process Panel, then press {Back} to return to the Aux Setup Menu.

FSN Series • User’s Guide • Rev 01 299