Manual background

3. Control Panel Orientation

Control Panel Descriptions

CUT

KEY 2

~Press CUT KEY 2 to immediately cut Key 2 fully on or off

Please note the following important points regarding the Direct Control buttons:

~Unlike the AUTO TRANS button, the two MIX KEY buttons cannot be paused. Once pressed, the transition completes fully.

~The buttons cannot be used to trigger DVE effects — but they can be used to mix or cut DVE effects on or off.

~When the T-Baris positioned between the BG and PST buses (off of a limit), almost all transitions are possible. For example:

S BG + MIX enabled — if the T-Baris positioned half-way between the BG and PST buses (creating a 50% mix), pressing CUT KEY 1 cuts the key in (or out) over the mix.

S BG + WIPE enabled — if the T-Baris positioned half-way between the BG and PST buses (creating a split-screen wipe), pressing MIX KEY 2 mixes in the key over the split screen.

S KEY 1 + MIX enabled — if the T-Baris positioned half-way between the BG and PST buses (creating a 50% mix of the key), pressing MIX KEY 1 mixes in the key to 100%.

S KEY 1 + WIPE enabled — if the T-Baris positioned half-way between the BG and PST buses (wiping the key halfway on), pressing MIX KEY 1 is inhibited. However, pressing CUT KEY 1 can be performed.

~The two MIX KEY buttons transition at the M/E’s auto transition rate. Use the Transition Menu to change rates. In Chapter 5, refer to the “Transition Menu” section on page 148 for complete details.

~The Transition LEDs do not change state when MIX KEY 1 and MIX KEY 2 are used.

90

 

FSN Series • User’s Guide • Rev 01

 

Page 90
Image 90
Barco 26-0702000-00 manual Control Panel Orientation, Control Panel Descriptions, FSN Series • User’s Guide • Rev