Barco 26-0702000-00 manual Menu Orientation, FSN Series • User’s Guide • Rev

Mask

5. Menu Orientation

System Menu

~Press {Source V Pos} or use the knob to change the vertical position inside the output’s boundaries along the Y axis.

~Press {Reset} to reset all pan and zoom values to default.

•In the Output Sizing and Scaling section, press {Mask} to display four “manual” mask value buttons, plus the convenient Output Mask Presets section. These functions enable you to mask (crop) the top, bottom, left, and right edges of the universal output. When a mask is applied on a selected edge, black is revealed in each masked section. All values are in percent, and the range is 0.00 to 100.0.

The following manual mask controls are provided:

~Press {Mask Top} or use the adjacent knob to manually mask the top edge of the universal output.

~Press {Mask Bottom} or use the knob to manually mask the bottom edge of the universal output.

~Press {Mask Left} or use the knob to manually mask the left edge of the universal output.

~Press {Mask Right} or use the knob to manually mask the right edge of the universal output.

~Press {Reset} to reset all mask values to default.

The figure below illustrates the Output Mask Presets section, which appears when {Mask} is pressed:

Mask Presets

16:9 5:4 4:3 3:2 1:1

Figure 5-121.Output Mask Presets Section

Note	All mask presets are additive. For example, if you mask to
	16:9 and then press 4:3, the system creates the 4:3 mask
	using the previous 16:9 image as a base.

The following preset functions are provided:

~Press {16:9} to mask the output to a 16:9 aspect ratio.

~Press {5:4} to mask the output to a 5:4 aspect ratio.

~Press {4:3} to mask the output to a 4:3 aspect ratio.

~Press {3:2} to mask the output to a 3:2 aspect ratio.

~Press {1:1} to mask the output to a 1:1 aspect ratio.

Remember that once the image is masked, you can use the {Fill H}, {Fill V} or {Fill H/V} functions to scale the image to the selected output resolution.

FSN Series • User’s Guide • Rev 01 251