Barco 26-0702000-00 manual gçóëíáÅâ, Control Panel Orientation, FSN Series • User’s Guide • Rev

3. Control Panel Orientation

Control Panel Descriptions

.

~Use the decimal button (.) for numeric entries that accept decimal values.

ENTER

Note	The decimal button is only applicable when certain Touch
	Screen keypad functions that accept decimal values are
	active. The button does not apply to memory registers.

~Press ENTER to complete a store, recall, or numeric entry function. For store and recall functions, once pressed, the selected modules are stored to memory or recalled to the panel, and all lit buttons in the Memory Section turn off.

gçóëíáÅâ

The Joystick is a three axis controller that is used to adjust a variety of switcher parameters. The figure below illustrates the Joystick and its three axes of control:

Y-Axis Control

Z-Axis Control

X-Axis Control

Figure 3-23. Joystick

For example, on the DVE Menu, when the Size and Position Tab is selected, the Joystick manipulates the PIP’s size and position as follows:

•X-Axis Control — Move the Joystick left and right to move the PIP left and right, respectively.

•Y-Axis Control — Move the Joystick up and down to move the PIP up and down.

•Z-Axis Control — Twist the Joystick’s top knob clockwise to increase PIP size, or counterclockwise to decrease PIP size.

In Chapter 8, refer to the “Joystick Control” section on page 361 for additional details on specific DVE Joystick control functions.

98 FSN Series • User’s Guide • Rev 01