Barco 26-0702000-00 manual bñíÉêå~ä=hÉó, Menu Orientation, FSN Series • User’s Guide • Rev

5. Menu Orientation

Keyer Menu

bñíÉêå~ä=hÉó

When the DSK is selected, the {External Key} button appears in the Tool Bar, adjacent to the {Type} button, as shown below:

External

Key

On

Figure 5-49.Keyer Menu: DSK (sample)

The {External Key} button is a toggle that enables or disables the ability to key using the external DSK Cut and Fill connections on the M/E card’s I/O panel. In Chapter 4, refer to the “External DSK Input Connections” section on page 125 for details.

•Select {On} to activate both external key connections.

~The label in the PGM Transition Display reads “EXT.”

~For the DSK, the labels in the Cut and Fill columns of the Keyer Status Table change to “EXTERNAL.”

~Video from the DSK Cut connector cuts the key hole, and video from the DSK Fill connector fills the hole.

~The Type and Key Fill buttons are grayed out.

Note	In this mode, when you press and hold DSK, no buttons are lit
	on the Phantom Key Bus (PST). However, when you make
	a selection on the Phantom Key Bus, the external key is
	automatically turned off and the new key source is accepted.

166 FSN Series • User’s Guide • Rev 01