Barco 26-0702000-00 manual System Setup, Native Input Setup, FSN Series • User’s Guide • Rev

6. System Setup

Native Input Setup

8.After a factory reset, the Sync Mode for all native inputs is set to Auto Sync. In this mode, the system automatically determines whether to set Auto: Minimum Delay mode or Auto: Frame Sync mode for each input. If Auto: Frame Sync is set, the system will not return to Auto: Minimum Delay mode until the sync processing is refreshed for the input.

To refresh sync for all inputs, press {Refresh All Sync}. Next, in the pop-up, press {Yes}. Native inputs set to Frame Sync or Minimum Delay modes will not be affected. Only inputs set to Auto: Frame Sync mode will be affected.

Note

Note

If you want to refresh sync for just a selected native input, use the {Refresh Sync} button on the Input Setup Menu.

This function does not apply to universal inputs.

„Color Correction — Use the following steps to set up native input color correction:

1.Press {Setup} to display the Input Setup Menu for the selected native input.

2.To adjust the input’s brightness, contrast and gamma, press {Bright Contrast Gamma}. Use the {Bright}, {Contrast} and {Gamma} controls as desired.

3.To adjust the input’s RGB brightness, press {RGB Bright}. Use the {Red Bright}, {Green Bright} and {Blue Bright} controls as desired.

4.To adjust the input’s RGB contrast, press {RGB Contrast}. Use the {Red Contrast}, {Green Contrast} and {Blue Contrast} controls as desired.

5.To adjust hue and color saturation, press {Hue Sat} and adjust as desired.

„Sync Setup — Use the following steps to set up native input sync:

1.Press {Sync Mode} to set the input’s synchronization mode. In the pop-up, select {Auto}, {Minimum Delay} or {Frame Sync} mode. In Chapter 5, refer to the “Understanding Sync Mode” section on page 211 for complete details.

2.Press {Refresh Sync} to refresh sync for the selected input only. This function is only required in Auto Sync mode. If the system switches from Auto: Minimum Delay to Auto: Frame Sync, the system will not return to Auto: Minimum Delay until the sync processing is refreshed.

„Mask Setup — Use the following steps to set up native input mask:

1.Press {Mask} to mask one or more edges of the video signal, if required. Use the {Mask Top}, {Mask Bottom}, {Mask Left} and {Mask Right} controls as required. When a mask is applied on an edge, black is revealed.

2.If required, press {Clear Mask} to clear all four masks to their default settings.

„Save Settings — Use the following steps to save input settings:

1.Press {Save Settings} to save the selected input’s setup parameters.

2.Press {Back} to return to the Input Menu.

3.Repeat from step 3 for each additional input that you wish to set up.

Important

Because you can install either a NIC or a UIC in slots 3 and 4, If you move or change card assignments in these two slots during setup, the setup is invalidated, and must be repeated once the final card configuration is reached.

292 FSN Series • User’s Guide • Rev 01