Barco 26-0702000-00 manual 3Backspace, 4Numerics, 6Close, 7Undo, 8Clear, 9Trim, Menu Orientation

5. Menu Orientation

Using the Keypad

register clears when you begin entering numbers, and digits shift left as you enter them. You must press {Enter} to complete an entry.

3)Backspace

Press Backspace {←} during a numeric entry process to clear the register by one digit with each press.

4)Numerics

Press the numeric buttons {0 - 9} to enter values. Digits shift left in the Register as you enter them. Use the {Decimal} button as required for entries that include decimal values.

5)+/-

Press {+/-}to invert the numeric entry in the Register (if applicable). For example, press {+/-}to change +350 to -350.

Note

6)Close

The {+/-}button is only applicable when certain Keypad functions that accept negative values are active.

Press {Close} to clear the Keypad from the Touch Screen, and “un-latch” the selected value button.

Note

7)Undo

If you press {Close} prior to pressing {Enter}, {Trim +} or {Trim -}, the Keypad clears, and the previous value is maintained.

Prior to pressing {Enter}, press {Undo} at any point during the numeric entry process to restore the original value, even if {Clear} or {+/-}was pressed.

Note

8)Clear

If {Enter} is pressed, that value becomes the new value to which the register will return, if {Undo} is pressed.

Press {Clear} during a numeric entry process to clear the register to 0 (zero).

9)Trim -

Enter an offset value using the numeric buttons, then press {Trim -}to subtract from the parameter’s current value. Pressing {Enter} is not required, and the “trim” value remains in the register, enabling you to trim repeatedly by the same offset. Once the value is trimmed, you can close the Keypad, or perform addition trims or entries in the normal way.

For example:

STo subtract 5 frames from a transition rate, press the Rate button for the desired M/E, then in the Keypad, press {5, Trim -}.

STo subtract 25 pixels from a mask value, press the desired mask edge (e.g., {Mask Top}), then in the Keypad, press {25, Trim -}.

FSN Series • User’s Guide • Rev 01 145