Barco 26-0702000-00 sáÉïáåÖ=jÉãçêó=oÉÖáëíÉêë, içÅâáåÖ=~åÇ=råäçÅâáåÖ=jÉãçêó=oÉÖáëíÉêë, Operations

7. Operations

Working with Memory Registers

sáÉïáåÖ=jÉãçêó=oÉÖáëíÉêë

In the View Mode, you can look at all memory registers, enter register descriptions, and view the status of all modules and Enables. You cannot modify the modules or the Enables within a register, but you can lock, unlock and delete registers.

„Use the following steps to view a memory register:

1.Navigate the Memory Menu using one of the following methods:

~In the Menu Bar, press {Page} to display page 2 (if required). Then, press the {Memory} button.

~Press and hold either the STORE or RECALL button in the control panel’s Memory Section.

2.Select the desired register that you want to view. Two methods are available:

~Turn the knob adjacent to the {Memory Register} button to scroll to the desired register.

~Press the {Memory Register} button, then on the keypad, enter the desired register and press {Enter}.

3.In the main Memory Table, note the register’s lock/unlock mode, description, and the exact modules stored in the register.

4.If desired, press {Description} to change the register’s description.

5.If desired, press {Advanced} to display the Advanced Memory Menu, where you can lock, unlock, and delete registers. Refer to the “Locking and Unlocking Memory Registers” and “Deleting Memory Registers”sections below for details.

6.If desired, press {Enables} to switch to the Enables Menu. There, you can view the module’s Enables, enter or change the description, and switch to the Advanced Memory Menu. If desired, you can also view other registers within the Enables Menu, using the same methods outlined in step 2 above.

içÅâáåÖ=~åÇ=råäçÅâáåÖ=jÉãçêó=oÉÖáëíÉêë

The View Mode is the only mode in which you can lock and unlock registers.

„Use the following steps to lock and unlock memory registers:

1.Ensure that you are not in the Store or Recall modes. If so, cancel the mode.

2.Navigate the Memory Menu using one of the following methods:

~In the Menu Bar, press {Page} to display page 2 (if required). Then, press the {Memory} button.

~Press and hold either the STORE or RECALL button in the control panel’s Memory Section.

3.Select the register that you want to lock or unlock. Two methods are available:

~Turn the knob adjacent to the {Memory Register} button to scroll to the desired register.

~Press the {Memory Register} button, then on the keypad, enter the desired register and press {Enter}.

4.Press {Advanced} to display the Advanced Memory Menu.

5.Press the {Lock Unlock} button to toggle the register’s mode.

344 FSN Series • User’s Guide • Rev 01