Barco 26-0702000-00 manual jÉãçêó=píçêÉ=kçíÉë, Operations, FSN Series • User’s Guide • Rev

7. Operations

Working with Memory Registers

11.Enter the desired description and press {Enter}.

Note

In Store Mode, the description will not appear in the register table until ENTER is pressed on the Keypad.

12.Press ENTER on the Keypad. The register is stored, the Enables are set, and the custom description is also stored. Above the Keypad, the selected register number and the custom description appear in the Memory Display, adjacent to the prefix “STR:”

jÉãçêó=píçêÉ=kçíÉë

Please note the following important points regarding memory register storage:

•If you are in the midst of a Store procedure, the {Advanced} button is grayed out. This feature prevents you from locking, unlocking, or deleting registers in the midst of the procedure.

•At any point, prior to pressing ENTER, you can add or remove modules within a pending Store operation — even if the module buttons were not originally selected in the Keypad’s Module Section.

For example:

SYou originally selected the M/E 1 module only, and you now wish to add one or two Aux routes to the register.

SYou originally selected the M/E 1 and PGM modules, but now you want to remove M/E 1 from the register.

To add modules (prior to pressing ENTER):

~In the Enables Menu, press the light blue button for module you wish to add (even if it was not originally selected). All Enables will be off initially, but as soon as you toggle any Enable on, the associated module button in the Keypad lights. You can also press {All On}.

~At any time in the pending Store procedure, simply light the desired module button in the Keypad. This action turn all Enables in the selected module on, then you can “set” them in the normal way.

To remove modules (prior to pressing ENTER):

~In the Enables Menu, press the light blue button for module you wish to remove, and press {All Off}. The associated module button in the Keypad turns off.

~At any time in the pending Store procedure, simply turn off the desired module button in the Keypad. This action turn all Enables in the selected module off — effectively removing the module from the register.

•Remember that once ENTER is pressed, the module’s contents are set — and you can no longer add to the register. On recall, however, you can elect to recall all of the register’s contents, or part of the contents by using your Enables.

FSN Series • User’s Guide • Rev 01 341