Barco 26-0702000-00 manual qê~åëáíáçå=iba=kçíÉë, bñ~ãéäÉ=OW==qJ_~ê=ãçîÉãÉåí=ïáíÜ=ãÉãçêó=êÉÖáëíÉêë

7. Operations

Understanding the T-Bar and Transition LEDs

6.Press AUTO TRAN to complete the transition. The Transition LEDs are all off, but the physical T-Barremains at 75%. In this situation, the T-Barhas no effect on the video until you move it to either limit.

bñ~ãéäÉ=OW==qJ_~ê=ãçîÉãÉåí=ïáíÜ=ãÉãçêó=êÉÖáëíÉêë

„Use the following steps to demonstrate physical vs. virtual T-Barposition, in conjunction with the recalling of memory registers:

1.In the M/E or the PGM bank, start with the T-Barat the bottom limit.

2.Manually move the T-Barto 25%. The Transition LEDs match the position.

3.For the bank in which you are working, save the bank in memory register 100. This memory register stores the T-Barposition by default. The register also stores the direction in which the T-Barwas moving.

4.Move the T-Barto 75%. The Transition LEDs match the position of the T-Bar.

5.Recall memory register 100 (in which the T-Barposition was saved at 25%). The Transition LEDs are at 25% and the physical T-Barposition is at 75%. Physical and virtual positions are not matched.

~If you move the T-Barto the top limit (the direction in which the transition was originally going), it has no effect on the video — because the T-Bar’s physical position is already past its virtual position.

~If you move the T-Barback down towards the bottom limit, you will match physical and virtual positions at 25% — at which point the T-Barwill again be live.

Tip

Always use the Transition LEDs to determine the T-Bar’s true virtual position.

qê~åëáíáçå=iba=kçíÉë

Please note the following important points regarding the Transition LEDs.

•(M/E bank only) The Transition LEDs are not affected when the two “mix” buttons in the Direct Key Control Group are used: MIX KEY 1 and MIX KEY 2. For example:

~In the M/E bank, press AUTO TRAN to start an automatic transition, and then press AUTO TRAN again to pause the transition. The Transition LEDs are now paused between the limits.

~Press MIX KEY 1 to mix on KEY 1. The Transition LEDs remain at their current location.

Refer to the “Working with Keys” section on page 333 for more details on the buttons in the Direct Key Control Group.

•(PGM bank only) The Transition LEDs are not affected when the FTB (Fade to Black) button is used. For example:

~In the PGM bank, press AUTO TRAN to start an automatic transition, and then press AUTO TRAN again to pause the transition. The Transition LEDs are now paused between the limits.

~Press FTB. The Transition LEDs remain at their current location.

FSN Series • User’s Guide • Rev 01 327