7)Direct Key Control Group
You can use AUTO TRAN and the T-Bartogether. For example, you can start a transition manually, and continue it automatically. In Chapter 7, refer to the “Working with Mixes” section on page 331 for full details.
Note
Use the Transition Menu to change transition rates and curves. Remember that the M/E’s transition rate appears in the Transition Display. In Chapter 5, refer to the “Transition Menu” section on page 148 for details.
Note
3. Control Panel Orientation
Control Panel Descriptions
S KEY 1 + MIX enabled — press AUTO TRAN to mix Key 1 on or off.
S BG + KEY 2 + MIX enabled — press AUTO TRAN to mix from BG to PST, and simultaneously mix Key 2 on or off.
S KEY 1 + KEY 2 + WIPE enabled — press AUTO TRAN to wipe Key 1 and Key 2 on or off.
S KEY 1 + FX TRIG enabled — press AUTO TRAN to trigger the DVE effect on Keyer 1 only.
S KEY 1 + MIX + FX TRIG enabled — press AUTO TRAN to mix the DVE effect up or down — and simultaneously trigger the effect.
Press AUTO TRAN during the transition interval to pause the transition. The Transition LEDS indicate the point at which the transition is paused. Press AUTO TRAN again to continue in the same direction. You can pause and continue repeatedly.

MIX

KEY 1

MIX

KEY 2

CUT

KEY 1

7)Direct Key Control Group

The four buttons in the Direct Key Control Group enable you to directly control the two keyers in the M/E, without the need to arm them in the Next Transition Group. When you use these buttons, the red LEDs above the KEY 1 and KEY 2 buttons function in the normal way.

MIX

MIX

KEY 1

KEY 2

CUT

CUT

KEY 1

KEY 2

Figure 3-17.Direct Key Control Group

Following are descriptions of each button in the Direct Key Control Group. The functions apply to the selected keyer, whether or not a DVE is assigned.

~Press MIX KEY 1 to immediately mix Key 1 fully on or off.

~Press MIX KEY 2 to immediately mix Key 2 fully on or off.

~Press CUT KEY 1 to immediately cut Key 1 fully on or off.

FSN Series • User’s Guide • Rev 01

 

89

 

Page 89
Image 89
Barco 26-0702000-00 manual 7Direct Key Control Group, FSN Series • User’s Guide • Rev, 17. Direct Key Control Group