tçêâáåÖ=ïáíÜ=táéÉë

7. Operations

Working with Wipes

tçêâáåÖ=ïáíÜ=táéÉë

WIPE

A Wipe is a transition in which one video signal is replaced with another signal, using a selected pattern to determine the edge between the two sources. The transition is always from the source on PGM (or BG) to the source on PST.

SPrerequisite — Ensure that you are familiar with the Wipe Menu. In Chapter 5, refer to the “Wipe Menu” section on page 151.

The following topics are discussed in this section:

Wipe Setup

Manual Wipe

Automatic Wipe

táéÉ=pÉíìé

„Use the following steps to set up the wipe:

1.Navigate to the Wipe Menu, either by pressing and holding the WIPE button in the desired bank, or by using the Menu Bar.

2.Select the desired wipe pattern, direction, edge type, edge width, and edge color (if Hard Edge is selected).

3.Set the desired auto transition rate and curve.

j~åì~ä=táéÉ

„Use the following steps to perform a manual wipe:

1.In the Next Transition Group, press BG.

2.On any PST bus, press the button for the desired “next” source. Remember that on the PGM bank, the M/E (re-entry) button can be preset in the same way.

3.Press WIPE.

4.Use the T-Barto perform the manual wipe.

^ìíçã~íáÅ=táéÉ

„Use the following steps to perform an automatic mix:

1.In the Next Transition Group, press BG.

2.On any PST bus, press the button for the desired “next” source. Remember that on the PGM bank, the M/E (re-entry) button can be preset in the same way.

3.Press WIPE.

4.Press AUTO TRAN.

Please note the following important points regarding wipes:

You can also press ALL TRAN (in the Custom Control Section) to perform a wipe on all buses simultaneously.

Remember that there are a wide variety of auto-transition combinations available to you. Refer to the “Automatic Transitions” section on page 325 for details.

332

 

FSN Series • User’s Guide • Rev 01

 

Page 332
Image 332
Barco 26-0702000-00 tçêâáåÖ=ïáíÜ=táéÉë, táéÉ=pÉíìé, j~åì~ä=táéÉ, ìíçã~íáÅ=táéÉ, •Wipe Setup •Manual Wipe •Automatic Wipe