Barco 26-0702000-00 manual rëáåÖ=^ìíçã~íáÅ=asb=qêáÖÖÉêë=, qêáÖÖÉê=~å=bÑÑÉÅí=çå=hÉóÉê=N=låäó

8. DVE Operations

Automatic DVE Triggering

rëáåÖ=^ìíçã~íáÅ=asb=qêáÖÖÉêë=

The following combinations of DVE triggers are discussed in this section:

•

•

•

•

•

•

•

•

•

•

•

Trigger an Effect on Keyer 1 Only

Trigger an Effect on Keyer 2 Only

Trigger Effects on both Keyers

Mix Key and Trigger an Effect on Keyer 1

Mix Key and Trigger an Effect on Keyer 2 Mix Key and Trigger Effects on both Keyers

Mix BG and Keyer 1, and Trigger Effect on Keyer 1 Mix BG and Keyer 2, and Trigger Effect on Keyer 2

Mix BG and both Keyers, Trigger Effects on both Keyers Wipe Trigger Options

Tap In, Tap Out Functions

Tip

On the control panel, practice each example below as you read along.

qêáÖÖÉê=~å=bÑÑÉÅí=çå=hÉóÉê=N=låäó

„Use the following steps to trigger a DVE effect on Keyer 1 only: 1. In the Next Transition Group, press KEY 1.

2. In the Effects Group, press FX TRIG. The label “ FX” appears in the Transition Display above KEY 1, indicating that the DVE effect is armed.

3.Press AUTO TRAN to run the effect forward or backward.

4.To cancel the trigger, press MIX or WIPE.

M	E M	F X K E Y 2	T R A N
2 1		C A M 1 G F X 2	3 0

BG

MIX

KEY

1

WIPE

KEY

2

FX

TRIG

Figure 8-24.Trigger DVE effect on Keyer 1

Important

If KEY 1 is not enabled on Program (with the red “on air” LED lit), you will not see the PIP flight occur, either on Preview or Program.

FSN Series • User’s Guide • Rev 01 401