Barco 26-0702000-00 manual jìäíáîáÉïÉê=`çååÉÅíáçåë, Installation, FSN Series • User’s Guide • Rev

4. Installation

Signal Connections

jìäíáîáÉïÉê=`çååÉÅíáçåë

The figure below illustrates monitor output connections on the MVR’s rear panel:

		(Optional) MVR:
		Slot 11
	1
	Digital	Multiviewer Output 1, DVI
	DVI	(Digital only)
		Multiviewer Output 1, SDI
	SDI
		Multiviewer Output 2, SDI
	Digital	Multiviewer Output 2, DVI
	DVI	(Digital only)
	2
LTC Input	Input
	LTC
Figure 4-20.Universal input connections

Please note:

•In both single and dual monitor configurations (as selected on the Multiviewer Setup Menu), the same signal appears on both the DVI-Iand BNC connectors.

„Use the following steps to connect MVR outputs to your monitor(s).

1.In single monitor configurations, use DVI and/or BNC cables to connect the DVI and/or SDI multiviewer output(s) to your monitor(s). The same signal appears on outputs 1 and 2.

2.In dual monitor configurations:

~Use DVI and/or BNC cables to connect the DVI and/or SDI multiviewer Monitor 1 output(s) to your assigned “left” monitor(s).

~Use DVI and/or BNC cables to connect the DVI and/or SDI multiviewer Monitor 2 output(s) to your assigned “right” monitor(s).

3.If you want to display time on the Multiviewer from an external LTC source, connect the output of your time code source (e.g., time code generator) to the LTC Input as follows:

~

~

For a differential connection, use the +, – and GND terminals. For a single-ended connection, use the + and GND terminals.

FSN Series • User’s Guide • Rev 01 129