Barco 26-0702000-00 asb=jçÇÉë=~åÇ=cÉ~íìêÉë, •DVE Channel Assignment, •Keyer Mode, DVE Operations

8. DVE Operations

Introduction to the DVE

3.Program DVE Effects — Using all available DVE tools, program and edit the desired effects on the DVE Menu. The best, most efficient method is:

~Store and name “shot box” keyframes for all of your desired positions, locations and looks.

~Create effects (either single or dual keyframe effects) from the shot box keyframes, and store them in memory. Remember that each DVE memory register stores all four channels currently being programmed, but using Enables, you can store any combination of channels.

Refer to the “Programming DVE Effects” section on page 391 for expanded instructions on programming and editing DVE effects.

4.Transition the Effect — On the panel, arm the desired keyer(s) in the M/E and/or in the PGM bank, and transition the effect(s) on or off. Please note:

~All DVE effects can be transitioned up or down in the normal way — using cuts, mixes and wipes.

~If a dual keyframe effect is programmed in an M/E keyer, the effect can be triggered either manually (with the DVE Menu), or automatically using the FX TRIG button in combination with the AUTO TRAN button.

Refer to the “Automatic DVE Triggering” section on page 396 for expanded instructions on triggering DVE effects.

asb=jçÇÉë=~åÇ=cÉ~íìêÉë

Following is a complete list of all DVE modes and features.

Note

All DVE modes and features are available in both Key and PIP modes (as selected on the Keyer Menu), except where noted below.

•DVE Channel Assignment

~Assign DVE channels to keyers, with independent cut/fill assignments

~Name DVE channels

~Un-assign DVE channels

•Keyer Mode

~Enable keyer mode or PIP mode for selected DVE channel

~Adjustable key gain, clip, and opacity

~Selectable key fill

•DVE Effects Setup

~Channel selection

~Create new effect

~Clear current keyframe

~Add keyframe

~Delete keyframe

•Keyframe Editing and Status

~Keyframe selection

FSN Series • User’s Guide • Rev 01 355