Manual background

7. Operations

Quick Setup and Operations

16.Save system configuration — After completing all “system” setups, save the configuration and back up the system.

~Chapter 6, Saving the Setup,” page 305.

~Chapter 6, Backing up the System,” page 305.

17.Set up Aux buses — As required, map all aux buses, and set up all Aux bus routes to peripheral destinations. (“Working with Aux Buses,” page 346.)

18.Set up Multiviewer — As required, set up the Multiviewer and assign sources to Multiviewer PIPs. (“Multiviewer Operations,” page 411.)

19.Set up transition rates — As required, set up all transition rates for all banks and FTB. (“Setting Transition Rates and Curves,” page 330.)

20.Set up wipes — Select the desired wipe patterns, and adjust direction and border type. (“Working with Wipes,” page 332.)

21.Set up keys — Select the desired key sources, and adjust type, fill, clip, gain and opacity as required. (“Working with Keys,” page 333.)

22.Set up and program DVE effects — If the optional DVE card(s) are installed, assign DVE channels to keyers and program the desired DVE effects. (Chapter 8, DVE Operations,” page 353.)

23.Set up memory registers — Set up the desired “looks” for your show, and store them in memory registers as required. (“Working with Memory Registers,” page 337.)

24.Ready to roll — With all output, input and system configurations saved, and all of your important “looks” stored in memory, put on your headsets and get busy!

Note

For detailed system operating procedures, specific system “tweaks” and operating descriptions on every feature, please start with the “Quick Function Reference” section on page 310, and select the function that you wish to perform.

FSN Series • User’s Guide • Rev 01

 

309

 

Page 309
Image 309
Barco 26-0702000-00 manual Operations, FSN Series • User’s Guide • Rev