Barco 26-0702000-00 6DVI Connector, 7CPU Switch, 8Ethernet Port, 9Ethernet Port, 10USB Ports

Models: 26-0702000-00

1 474
Download 474 pages 62.9 Kb
Page 100
Image 100
6)DVI Connector

3. Control Panel Orientation

Control Panel Rear

6)DVI Connector

One DVI connector is provided to connect the control panel to the Touch Screen. Use the supplied cable harness for interconnection. In Appendix A, refer to the DVI-I Connector” section on page 440 for pinout details.

7)CPU Switch

The CPU Switch is located inside the small hole. This switch is designed for qualified service personnel only.

Important

8)Ethernet Port 1

Do not use this switch unless instructed to do so by Barco Customer Service personnel.

One RJ-45 connector is provided for 10/100BaseT Ethernet communications. Port 1 is connects to the FSN-1400, either directly or via an Ethernet Switch. By default, the following conditions are set:

~

~

~

DHCP = OFF

Default IP address: 192.168.0.5

Default Netmask: 255.255.255.0

The user can use the default address, or set a different address. In Appendix A, see the “Ethernet Connector” section on page 441 for pinouts.

9)Ethernet Port 2

One RJ-45 connector is provided for 10/100BaseT Ethernet communications. Port 2 can be connected to an outside network, or to your facility’s “house” network. By default, the following conditions are set:

DHCP = ON

An IP address can be obtained automatically from the outside network. In Appendix A, see the “Ethernet Connector” section on page 441 for pinouts.

10)USB Ports

Four USB ports are provided. Use one of the four ports to connect data to the Touch Screen, using the supplied cable harness for interconnection. The remaining ports can be used for connecting customer-supplied USB drives, or if required, to connect a mouse and keyboard.

11)DC Power Out

One DC Power Out connector is provided for the Touch Screen power. Use the supplied cable harness for interconnection.

12)Audio Connectors

The three audio connectors are not supported.

13)Fan

One Fan is provided for control panel cooling. To prevent overheating, do not block the vent.

14)AC Power

One AC Connector is provided for connecting the control panel to AC. The integral switch turns the panel on and off. In Appendix A, refer to the “Physical and Electrical Specifications” section on page 435 for power details.

100

 

FSN Series • User’s Guide • Rev 01

 

Page 100
Image 100
Barco 26-0702000-00 6DVI Connector, 7CPU Switch, 8Ethernet Port, 9Ethernet Port, 10USB Ports, 11DC Power Out, 13Fan, ~ ~ ~