12)Loop

2. FSN-1400 Orientation

Card Descriptions

12)Loop

One BNC connector is provided for a reference Loop connection, which enables you to loop the incoming reference signal to the next device in your system. If the reference Loop is not used, connect a 75 ohm terminator to the connector.

13)Ref Out

One BNC connector is provided for a Reference Output signal. Using the {Reference Out} button on the Reference and Output Setup Menu, this output can be toggled between Tri-Level Sync and Black Burst.

Important

The sync out format (as provided on the connector) changes, depending on the selected native video format. In Appendix A, refer to the “Reference Video Output Specifications” section on page 434 for details.

14)Tally Connector

One DB-50 connector is provided for tally, with 24 contact closures available. In Appendix A, refer to the “Tally Connector” section on page 443 for pinouts. In Chapter 6, refer to the “Tally Setup” section on page 303 for setup details.

15)GPIO Connector

One DB-25 connector is provided for GPIO, with four input ports and eight output ports. In Appendix A, refer to the “GPIO Connector” section on page 444.

Note

This function is currently not implemented.

FSN Series • User’s Guide • Rev 01

 

47

 

Page 47
Image 47
Barco 26-0702000-00 manual 12Loop, 13Ref Out, 14Tally Connector, 15GPIO Connector, FSN-1400Orientation