Barco 26-0702000-00 tçêâáåÖ=ïáíÜ=jáñÉë, j~åì~ä=jáñ, ìíçã~íáÅ=jáñ, •Manual Mix •Automatic Mix

7. Operations

Working with Mixes

tçêâáåÖ=ïáíÜ=jáñÉë

MIX

A Mix (or “dissolve”) is a transition in which one video signal fades out as another fades in. The transition is always from the source on PGM (or BG) to the source on PST.

The following topics are discussed in this section:

•Manual Mix

•Automatic Mix

j~åì~ä=jáñ

„Use the following steps to perform a manual mix:

1.In the Next Transition Group, press BG.

2.On any PST bus, press the button for the desired “next” source. Use the SHIFT button if required to select a shifted source. Remember that on the PGM bank, the M/E (re-entry) button can be preset in the same way.

3.Press MIX.

4.Use the T-Barto perform the manual mix.

^ìíçã~íáÅ=jáñ

„Use the following steps to perform an automatic mix:

1.Set the desired auto transition rate and curve. Refer to the “Setting Transition Rates and Curves” section on page 330 for details.

2.In the Next Transition Group, press BG.

3.On any PST bus, press the button for the desired “next” source. Use the SHIFT button if required to select a shifted source. Remember that on the PGM bank, the M/E (re-entry) button can be preset in the same way.

4.Press MIX.

5.Press AUTO TRAN.

Please note the following important points regarding mixes:

•You can also press ALL TRAN (in the Custom Control Section) to perform a mix on all buses simultaneously.

•Remember that there are a wide variety of auto-transition combinations available to you. Refer to the “Automatic Transitions” section on page 325 for details.

FSN Series • User’s Guide • Rev 01 331