Barco 26-0702000-00 nìáÅâ=pÉíìé=~åÇ=léÉê~íáçåë, Operations, ~ , “Touch Screen Installation,” page

7. Operations

Quick Setup and Operations

nìáÅâ=pÉíìé=~åÇ=léÉê~íáçåë

For the optimum speed in setting up and operating your FSN Series switcher, use the following steps. For reference, links are provided to the appropriate sections in this guide.

Note

Many of these steps were already covered in Chapter 4 and Chapter 6. As required, use the following list as an easy check-list for all quick setup requirements.

1.Connect power — Ensure that power is properly connected to all FSN Series components.

~Chapter 4, “Control Panel Installation,” page 106

~Chapter 4, “Touch Screen Installation,” page 107

~Chapter 4, “FSN-1400 System Connections,” page 112

2.Connect inputs — Connect all input sources to the FSN Series. (Chapter 4, “Signal Connections,” page 121.)

3.Connect outputs — Connect the output(s) of the FSN Series to your target devices. (Chapter 4, “Signal Connections,” page 121.)

4.Turn on power — Turn on power to all FSN Series components, and to all peripheral equipment. (Chapter 6, “Power Up and Status Check,” page 282.)

5.Factory reset — If you are using the FSN Series for the first time, or if you are using a system that has just returned from another event, perform a full factory reset. (Chapter 6, “Return to Factory Default,” page 283.)

6.Set reference video — Set the desired reference video mode. (Chapter 6, “Reference Video and Output Setup,” page 287.)

7.Set output format — Set the desired output resolution and frame rate. (Chapter 6, “Reference Video and Output Setup,” page 287.)

8.Set clean feeds — Set the desired clean feed output points. (Chapter 6, “Clean Feed Setup,” page 290.)

9.Enable test patterns — If required, use test patterns to verify outputs and make the necessary adjustments. When complete, turn off the test patterns.

(Chapter 6, “Output Test Patterns,” page 289.)

10.Set up native inputs — As required, set up all native inputs, and perform the necessary adjustments. (Chapter 6, “Native Input Setup,” page 291.)

11.Set up universal inputs — As required, set up all universal inputs, and perform the necessary adjustments. (Chapter 6, “Universal Input Setup,” page 293.)

12.Set up external DSK inputs — As required, set up the external DSK inputs, and perform the necessary adjustments. (Chapter 6, “External DSK Input Setup,” page 296.)

13.Complete button mapping — Complete the button mapping on the control panel, including all inputs, color background signals and test patterns. (Chapter 6, “Button Mapping,” page 303.)

14.Complete tally connections — Complete all system tally relay connections. (Chapter 6, “Tally Setup,” page 303.)

15.Set up user preferences — Complete all user preference choices, as required. (Chapter 6, “User Preferences Setup,” page 304.)

308 FSN Series • User’s Guide • Rev 01