qçìÅÜ=pÅêÉÉå=fåëí~ää~íáçå

4. Installation

Touch Screen Installation

5.Connect the supplied AC Power Cord to the AC connector on the rear of the Control Panel, and then to an AC outlet.

Note

Connect the Control Panel to a properly rated supply circuit. Refer to the “Power Cord/Line Voltage Selection” section on page 115 for details.

qçìÅÜ=pÅêÉÉå=fåëí~ää~íáçå

The figure below illustrates a simplified rear view of the Touch Screen and the supplied desk stand. Use this figure for reference during the following procedure.

VESA Mounting

Plate

Touch Screen

Connector Panel

Screw

Holes

Figure 4-2.Touch Screen and Desk Stand

Kensington Security

Slot

Lock Knob

Cable Access

Cable Mounts

„Use the following steps to install the Touch Screen and desk stand:

1.Using the supplied screws, attach the VESA mounting plate to the rear of the Touch Screen.

2.Thread the supplied cable harness through the cable access hole in the desk stand. Ensure that the end with the large USB connector points towards the Touch Screen. Be sure to leave an ample service loop.

FSN Series • User’s Guide • Rev 01

 

107

 

Page 107
Image 107
Barco 26-0702000-00 manual qçìÅÜ=pÅêÉÉå=fåëí~ää~íáçå, Installation, FSN Series • User’s Guide • Rev