10. Updating Software

10. Updating Software

Software Update Overview

pçÑíï~êÉ=réÇ~íÉ=lîÉêîáÉï

Firmware files for the FSN-1400 and control panel are loaded into the hardware at power- up. These files are stored in the unit’s onboard flash memory. Two different update procedures can be performed:

Update FSN-1400 and Control Panel — This procedure updates both the control panel and the FSN-1400. A “new” software update file is required.

Update FSN-1400 only — This procedure updates the FSN-1400 software to match the control panel software. Use this procedure if the label “Mismatch” appears in the System Status Table on the System Menu.

„For a “new” software update, following is an overview of the steps required:

1.Verify your hardware. Refer to the “Hardware Requirements” section below.

2.Download the appropriate “update” file. Refer to the “Downloading Software” section on page 427.

3.Transfer the software to a USB thumb drive.

4.Insert the USB drive into the control panel’s top USB port.

5.In the Navigation Bar, press {System} to display the System Menu.

6.Press {Software} to display the Software Menu.

7.To update the control panel, refer to the “Updating Control Panel Software” section on page 429.

8.To update the FSN-1400, refer to the “Updating FSN-1400 Software” section on page 430.

e~êÇï~êÉ=oÉèìáêÉãÉåíë

The following hardware items are required for upgrading FSN Series software:

IBM compatible computer with an available Ethernet port and USB port.

USB thumb drive, minimum 1 GB.

Internet connection.

426

 

FSN Series • User’s Guide • Rev 01

 

Page 426
Image 426
Barco 26-0702000-00 pçÑíï~êÉ=réÇ~íÉ=lîÉêîáÉï, e~êÇï~êÉ=oÉèìáêÉãÉåíë, Updating Software, FSN Series • User’s Guide • Rev