Barco 26-0702000-00 manual ëëáÖå=_ìííçå, Menu Orientation, FSN Series • User’s Guide • Rev

Assign Button

5. Menu Orientation

System Menu

Three mutually exclusive clean feed points are provided for M/E 2’s clean feed output:

•Press {M/E 2 Clean 1} to select the clean feed point prior to Keyer 1.

•Press {M/E 2 Clean 2} to select the clean feed point prior to Keyer 2.

•Press {M/E 2 Out} to select the M/E 2 program output.

Two mutually exclusive points are provided for the PGM bank’s clean feed output.

•Press {PGM Clean} to select the clean feed point prior to the DSK.

•Press {PGM Out} to select the program output (after the DSK).

^ëëáÖå=_ìííçå

Press {Assign Button} to select the clean feed source that is mapped to the ASSIGN button in the control panel’s Aux Section. This feature enables you to place a clean feed source on the Aux Source Row, and select it (just as you would any other available source), and send it to an Aux bus destination.

When {Assign Button} is pressed, the Palette changes to display a different “flow-chart.” This diagram represents the clean feed points that can be mapped to the ASSIGN button, with buttons provided for each selection point.

Figure 5-106.Clean Feed Setup Menu, Assign Button selection (sample)

One of three mutually exclusive clean feed points can be mapped to the ASSIGN button:

•Press {M/E 1 Clean 1} to select the clean feed point prior to M/E 1, Keyer 1.

•Press {M/E 1 Clean 2} to select the clean feed point prior to M/E 1, Keyer 2.

FSN Series • User’s Guide • Rev 01 233