Barco 26-0702000-00 manual hÉóÉê=jÉåì=^ÅÅÉëë, hÉóÉê=pí~íìë=q~ÄäÉ, Menu Orientation

5. Menu Orientation

Keyer Menu

hÉóÉê=jÉåì=^ÅÅÉëë

There are two ways to access the Keyer Menu:

•In the Menu Bar, press {Page} to display page 1 (if required). Then, press the {Keys} button. The parameters for the last selected keyer are displayed.

•Arm the desired keyer first, then press and hold that Keyer button (e.g., KEY 1 or KEY 2 in the M/E 1 bank, or the DSK button in the PGM bank). The parameters for that specific keyer are displayed, and the location is named in the Title Bar (e.g., Keyer Menu: M/E 1, Key 1).

hÉóÉê=pí~íìë=q~ÄäÉ

A Keyer Status Table is displayed at the top of the Palette, as shown below:

Keyer	Cut	Type	Fill	DVE Cut Channel	DVE Fill Channel
M/E 1, Key 1	CAM1	Luma	Self	DVE-1 - ON	N/A
M/E 1, Key 2	PC	Luma	Self	DVE-2 - ON	N/A
M/E 2, Key 1	CAM2	Luma	Matte	N/A	N/A
M/E 2, Key 2	CHY1	Luma	Self	N/A	N/A
DSK	BLK	Luma	Self	N/A	N/A

Figure 5-39.Keyer Status Table (sample)

In the table, rows are provided for each keyer on the panel, and the yellow highlight shows the active keyer. This highlight changes automatically when different keyers are selected. The following columns of information are provided:

•Keyer — Indicates the name of each keyer on the panel.

•Cut — Indicates the key’s cut source, as selected on the bank’s Key Bus.

•Type — Indicates the key type, either Luma or Linear, as selected with the {Type} button. Refer to the “Type” section on page 160 for details.

•Fill — Indicates the key’s fill source, either Self, Split, Matte or PST (Preset Bus), as selected with the {Key Fill} button. If the key is split, the name of the split fill source appears in the cell. Refer to the “Key Fill” section on page 162 for details.

•DVE Cut Channel — Indicates the name of the DVE channel assigned to the keyer’s cut signal, as performed on the DVE Assign Menu. Please note:

~The status of the assigned DVE channel (either ON or OFF) is appended to the DVE channel’s name.

~The field reads “N/A” if no DVE is assigned to the keyer.

•DVE Fill Channel — Indicates the name of the DVE channel assigned to the keyer’s fill signal, as performed on the DVE Assign Menu.

~The status of the assigned DVE channel (either ON or OFF) is appended to the DVE channel’s name.

~The field reads “N/A” if no DVE is assigned to the keyer.

Note

Refer to Chapter 8, “DVE Operations” on page 353 for details on assigning DVE channels.

158 FSN Series • User’s Guide • Rev 01