`~êÇ=fåëÉêíáçå

4. Installation

Card and Rear Panel Installation

`~êÇ=fåëÉêíáçå

„To insert a card:

1.Use Table 4-4 on page 116 to verify the slots in which the card can be installed.

2.Once verified, open the chassis front door and remove it (if desired). In Chapter 2, refer to the “Chassis Front Door” section on page 37 for details.

3.Orient the card so that the label (e.g., UIC or NIC) is at the top. Ensure that both ejectors are unlatched from the slots in the card’s front plate.

4.Once unlatched, hold the top ejector up, as shown below. The bottom ejector will automatically fall away from the front of the card.

Hold up top Ejector

Card

Bottom Ejector

Figure 4-11.Ejector Orientation prior to card insertion

118

 

FSN Series • User’s Guide • Rev 01

 

Page 118
Image 118
Barco 26-0702000-00 manual `~êÇ=fåëÉêíáçå, Installation, FSN Series • User’s Guide • Rev