Barco 26-0702000-00 manual bñíÉêå~ä=aph=fåéìí=pÉíìé, System Setup, FSN Series • User’s Guide • Rev

6. System Setup

External DSK Input Setup

bñíÉêå~ä=aph=fåéìí=pÉíìé

	FSN Series system setup: Step 11
11	In this procedure, you will set up the external DSK inputs.
		S Prerequisite — Ensure that you are familiar with the following menus:
		~ External DSK Setup Menu — Chapter 5, “External DSK Setup Menu,”
		page 229.
		~ Connector Colors — Chapter 5, “Connector Colors,” page 204.
	„ Error Reporting — Use the following steps to set external DSK error reporting:
	1.	In the Menu Bar, press {System} to access the System Menu.
	2.	Press {External DSK Setup} to display the External DSK Setup Menu.
	3.	In the Rear I/O View, press the DSK Cut connector.
	4.	Toggle the {Error Reporting} button either On or Off, as desired. The table’s
		Error Reporting column indicates your selection.
		~ If you elect not to use the external DSK input, turn error reporting off to
		prevent error messages.
		~ If you elect to use the input, ensure that your source is properly
		connected to the FSN-1400.
	5.	Press the DSK FIll connector, and repeat step 4.
	„ Input Sync — Use the following steps to set up external DSK input sync:
	1.	In the Rear I/O View, press the DSK Cut connector.
	2.	Press {Sync Mode}. In the pop-up, select {Auto}, {Minimum Delay} or {Frame
		Sync}. In Chapter 5, see the “Understanding Sync Mode” section for details.
	3.	If required, press {Refresh Sync}. This function is only required in Auto Sync
		mode. If the system switches from Auto: Minimum Delay to Auto: Frame Sync,
		the system will not return to Auto: Minimum Delay until sync is refreshed.
	4.	Press the DSK FIll connector, and repeat steps 2 and 3.
	„ Save Settings — Use the following steps to save DSK input settings:
	1.	Press {Save Settings} to save all DSK input setup parameters.
	2.	Press {Back} to return to the System Menu.

296 FSN Series • User’s Guide • Rev 01