Barco 26-0702000-00 píçêáåÖ=jÉãçêó=oÉÖáëíÉêë, píçêÉI=_óé~ëë=bå~ÄäÉëI=rëÉ=aÉÑ~ìäí=k~ãÉ, Operations

7. Operations

Working with Memory Registers

The table below summarizes the functions you can perform in each mode:

Table 7-3.Memory Menu modes and functions

Memory Menu	Name			Lock	Delete
Mode	Registers	Modules	Enables	Registers	Registers
View	Yes	View Only	View Only	Yes	Yes
Store	Yes	Modify	Modify	No	No
Recall	No	Modify	Modify	No	No

píçêáåÖ=jÉãçêó=oÉÖáëíÉêë

When you store a memory register, you take a “snapshot” of the switcher and the selected modules. Once stored, you can not add data to that register — you can only overwrite it with new data.

SIf you store M/E 1 into register 100, you can not add AUX data into that register. However, you could overwrite register 100 with new data.

Storing a memory register and bypassing the Enables is an easy equation. This method stores the entire contents of the selected module(s).

•STORE, [enable/disable modules], [select register #], ENTER

Storing a memory register and setting Enables is also an easy equation. This method stores partial contents of the selected module(s).

•STORE, [enable/disable modules], [select register #], [set Enables], ENTER The following topics are discussed in this section:

•

•

•

•

Store, Bypass Enables, Use Default Name Store, Bypass Enables, Enter Custom Name Store, Set Enables, Enter Custom Name Memory Store Notes

píçêÉI=_óé~ëë=bå~ÄäÉëI=rëÉ=aÉÑ~ìäí=k~ãÉ

„Use the following steps to store a memory register, bypass the Enables menu, and use the default register name:

1.Set up the switcher in the exact configuration that you want stored.

2.On the Keypad, press STORE. By default, all available modules light in the keypad’s Module Section.

3.Select the desired modules to include (or exclude) in the register. If you don’t take any action, all modules remain enabled.

4.Enter the desired register number.

5.Press ENTER. The register is stored in memory with all Enables are on, and a default description is assigned (reg-#). Above the Keypad, the selected register number and the default description “reg-#” appear in the Memory Display, adjacent to the prefix “STR:”

FSN Series • User’s Guide • Rev 01 339