Barco 26-0702000-00 manual mçëáíáçå=mêÉëÉíë, ëéÉÅí=o~íáç, DVE Operations

8. DVE Operations

DVE Menu Orientation

•Press {1/2} to set H Size to one-half native resolution H Size.

•Press {3/4} to set H Size to three-quarters native resolution H Size.

•Press {Full} to set H Size to the native resolution’s H Size.

mçëáíáçå=mêÉëÉíë

The Position Preset section enables you to set PIP or key position without affecting the current size. In the figure below, letters have been added to assist with each button’s description. These letters do not appear on the Palette.

Position

a.	b.
d.	e.
f.	g.
i.	j.

k. l.

Figure 8-9.DVE Size Presets

c.

h.

m.

Aspect

Ratio

16:9

The central frame represents the screen raster.

•Off Screen Corners — Press buttons a, c, k and m to position the PIP (plus its border and shadow), completely off screen by 1 pixel — in the corner as indicated. The PIP or Key’s current size is not affected.

•Over the Shoulder, Under the Shoulder — Press buttons d, e, i and j to position the PIP and its border N pixels from the H and V edge of the active picture area. N is defined as 5% of the H active value for the current output resolution. The shadow is ignored when using these four buttons.

•Off Screen Center, Top and Bottom — Press buttons b and l to set the PIP’s H position to 0 (zero) along the X Axis, and the PIP’s V position (including its border and shadow), completely off screen by 1 pixel along the Y Axis.

•Off Screen Center, Left and Right — Press buttons f and h to set the PIP’s V position to 0 (zero) along the Y Axis, and the PIP’s H position (including its border and shadow), completely off screen by 1 pixel along the X Axis.

•Center Screen — Press button g to set the PIP’s H and V position to 0 (zero) along both axes.

^ëéÉÅí=o~íáç

•To change the PIP or key’s aspect ratio, press {Aspect Ratio} to display the Aspect Ratio Pop-up. This function affects the H dimension only. Choices are 16:9, 5:4, 4:3, 3:2, 1:1 and Custom.

When {Custom} is selected, the {Adjust Custom Aspect} button appears in the Tool Bar. Press to display the {Custom Aspect} value button. Unlatch to re- display size and position adjustments.

370 FSN Series • User’s Guide • Rev 01