Barco 26-0702000-00 manual Menu Orientation, System Menu, FSN Series • User’s Guide • Rev

5. Menu Orientation

System Menu

Active

and

Pos

Sync

Offset Timing

Offset

Timing

Info

~Press {V Total} or use the adjacent Knob to set the desired total number of vertical lines in the output image.

Important	Changing the H and V Totals will cause a disruption to the
	UOC’s output video. Press {Apply} to apply changes, or
	{Undo} to reverse un-applied changes.

•Press {Active and Pos} to set the H and V active area, and the H and V position. Four value buttons appear:

~Press {H Pos} or use the adjacent Knob to set the start of the active area’s horizontal offset from H sync, in pixels.

~Press {V Pos} or use the adjacent Knob to set the start of the active area’s vertical offset from V sync, in lines.

~Press {H Active} or use the adjacent Knob to set the width of the active area, in pixels.

~Press {V Active} or use the adjacent Knob to set the number of active vertical lines in the output.

•Press {Sync} to adjust the horizontal and vertical sync pulse width. Two value buttons appear:

~Press {H Sync} or use the adjacent Knob to adjust the horizontal sync pulse width, in pixels.

~Press {V Sync} or use the adjacent Knob to adjust the vertical sync pulse width, in lines.

•Press {Offset Timing} to adjust the UOC output’s video timing relative to the system’s native resolution. Please note:

~If the selected UOC output format is vertically locked to the native resolution’s vertical sync, the {Offset Timing} button is active.

~If the selected UOC format is not vertically locked to the native resolution’s vertical sync, the {Offset Timing} button is grayed out.

When {Offset Timing} is pressed, two value buttons appear, along with the {Offset Timing Info} button:

~Press {H Offset} or use the adjacent Knob to offset the output’s horizontal timing (in pixels), relative to the timing of the system’s native resolution. The adjustment range is +/- 1/2 line.

~Press {V Offset} or use the adjacent Knob to offset the output’s vertical horizontal timing (in lines), relative to the timing of the system’s native resolution. The adjustment range is +/- 1/2 frame.

•Press {Offset Timing Info} to display a pop-up with the following important information on video output offset timing:

~If the reference input is set to External, H and V offsets adjust the video output relative to the video reference input. H and V can be positive or negative values.

~If the reference input is set to Free Run, H and V offsets adjust the video output relative to the switcher’s internal Black signal.

Note that the system’s reference input is set on the Reference and Output Setup Menu. Refer to the “Reference and Output Setup Menu” section on page 197 for details.

248 FSN Series • User’s Guide • Rev 01