Barco 26-0702000-00 rëáåÖ=`ìëíçã=`çåíêçä=cìåÅíáçåë, Operations, FSN Series • User’s Guide • Rev

7. Operations

Using Custom Control Functions

rëáåÖ=`ìëíçã=`çåíêçä=cìåÅíáçåë

The Custom Control Section provides groups of buttons that can be programmed to perform various switcher functions.

SPrerequisites — Ensure that you are familiar with the Custom Control Section. In Chapter 3, refer to the “Custom Control Section” heading on page 93 for details.

Note

In version 3.0, only pre-programmed “system” functions such as ALL TRAN, FRZ, UNFRZ, etc., are available.

„Use the following steps to use Custom Control functions:

1.To freeze a source:

~Press and hold FRZ, then press the desired source button (on any bus). Note that this is the same as toggling the {Freeze} button to “On” — on the Input Menu.

2.To un-freeze a source:

~Press and hold UNFRZ, then press the button for the frozen source (on any bus). Note that this is the same as toggling the {Freeze} button to “Off” — on the Input Menu.

3.To perform an auto transition on all banks simultaneously:

~Press ALL TRAN. All banks will transition, each at their own selected transition rate.

4.To perform a cut on all banks simultaneously:

~Press ALL CUT. All banks will cut immediately.

5.To enable or disable M/E 2 control on the FSN-150:

~Toggle the M/E2 CTRL button:

•

•

Important

When enabled, the Custom Control button lights solid, and all Programmable Displays on the M/E turn orange. Refer to the “M/E 2 Control on the FSN-150” section on page 349 for operating instructions.

When disabled, the Custom Control button turns off, and all Programmable Displays on the M/E turn green.

When M/E 2 control is off, it simply means that the bank’s buttons are not physically on the FSN-150 panel. You still have the ability to recall all stored M/E 2 memory registers in the normal manner.

6.To save all system settings:

~Press SAVE ALL. All parameters under the System Menu will be saved to non-volatile memory. Note that this function is the same as pressing {Save All} on the System Menu. In Chapter 5, refer to the “Save All” section on page 272 for a list of the functions that are saved.

348 FSN Series • User’s Guide • Rev 01