Barco 26-0702000-00 manual pÉííáåÖ=qê~åëáíáçå=o~íÉë=~åÇ=`ìêîÉë, Operations

7. Operations

Setting Transition Rates and Curves

pÉííáåÖ=qê~åëáíáçå=o~íÉë=~åÇ=`ìêîÉë

The Transition Menu enables you to change auto transition rates and transition curves.

SPrerequisite — Ensure that you are familiar with the Transition Menu. In Chapter 5, refer to the “Transition Menu” section on page 148.

„Use the following steps to set transition rates and curves:

MIX

1.Navigate to the Transition Menu, either by pressing and holding any MIX button, or by using the Menu Bar.

2.To adjust transition rates with the knobs:

~Turn the knob adjacent to the M/E 1 or M/E 2 button to adjust the rate.

~Turn the knob adjacent to the PGM button to adjust the PGM rate.

~Turn the knob adjacent to the FTB button to adjust the FTB rate.

3.To adjust transition rates with the Keypad:

~Press the M/E 1 or M/E 2 button to display the Keypad. Enter or trim the transition rate for the M/E, then press {Enter} to accept.

~Press the PGM button to display the Keypad. Enter or trim the transition rate for the PGM bank, then press {Enter} to accept.

~Press the FTB button to display the Keypad. Enter or trim the transition rate for the FTB, then press {Enter} to accept.

4.To adjust all transition rates simultaneously, press {All/Set Trim}.

~To “set” a new rate, press any value button to display the Keypad.

•To set all rates to the value in the register, press {Enter}.

•To set all rates to a value, enter the value and press {Enter}.

~To trim all rates simultaneously as offsets to their current values:

•Turn any Knob to increment or decrement all rates.

•

Note

Press any value button to display the Keypad. Enter the desired “trim” value and press {Trim +} or {Trim -}as desired.

The M/E 1 transition rate applies to the buttons in the Direct Key Control Group (MIX KEY 1 and MIX KEY 2).

5.Transition curves are applied when you press AUTO TRAN in a selected bank, or the FTB button. To select transition curves:

~For M/E 1 or M/E 2, press the {Linear}, {S Curve}, {Exponential}, or {Logarithmic} button in the row adjacent to the desired button.

~For the PGM bank curve, press the {Linear}, {S Curve}, {Exponential}, or {Logarithmic} button in the row adjacent to the PGM button.

~For the FTB curve, press the {Linear}, {S Curve}, {Exponential}, or {Logarithmic} button in the row adjacent to the FTB button.

Note

Transition curves also apply to the buttons in the Direct Key Control Group (MIX KEY 1 and MIX KEY 2).

330 FSN Series • User’s Guide • Rev 01