Barco 26-0702000-00 manual oÉÑÉêÉåÅÉ=sáÇÉç=~åÇ=lìíéìí=pÉíìé, System Setup

6. System Setup

Reference Video and Output Setup

oÉÑÉêÉåÅÉ=sáÇÉç=~åÇ=lìíéìí=pÉíìé

	FSN Series system setup: Step 6
6	In this procedure, you will set up the system’s video reference input, output format (native
	resolution), and the output V-Lock setting.

S Prerequisite — Ensure that you are familiar with the Reference and Output Setup Menu. In Chapter 5, refer to the “Reference and Output Setup Menu” section on page 197.

„ Set up reference — Use the following steps to set up video reference input: 1. In the Menu Bar, press {System} to access the System Menu.

2. Press {Ref and Output Setup} to display the Reference and Output Setup Menu.

3. Press {Reference Input} to display two reference options:

~ Press {Free Run} to select the FSN-1400’s internal sync generator as the reference.

~ Press {External} to select the REF IN connector on the System Card. One of three external signals can be connected:

•

•

•

Note

SMPTE bi-level sync

Tri-level sync

Black burst

If External is selected, ensure that the proper signal is connected to the REF IN connector on the System Card. In Appendix A, refer to the “Reference Video Input Specifications” section on page 433 for detailed information about the allowed frame rates for the reference input.

„Set up format — Use the following steps to set up the output format:

1.On the Reference and Output Setup Menu, press {Output Format} to display the Output Format Keypad.

2.Select the desired format and press {Apply}. In the confirmation pop-up, click {Set Output Format} to confirm.

Important

Remember that all input settings will be reset to their default values when you change output formats.

FSN Series • User’s Guide • Rev 01 287