lìíéìí=`çååÉÅíáçåë

4. Installation

Signal Connections

lìíéìí=`çååÉÅíáçåë

The figure below illustrates the output connections on the M/E card’s rear panel:

Program Out 2 Manual background

Program Out 1 Manual backgroundManual background

Preview Out Manual backgroundManual background

Clean Out Manual backgroundManual background

M/E 1 Program Out Manual backgroundManual background

M/E 1 Preview Out Manual backgroundManual background

M/E 1 Clean Out Manual backgroundManual background

M/E 2 Program Out Manual backgroundManual background

M/E 2 Preview Out Manual backgroundManual background

M/E 2 Clean Out Manual backgroundManual background

Manual background PGM Manual background

PVW

DSK

 

CLN

 

PGM

 

M/E 1

 

PVW

 

CLN

AUX

 

PGM

 

M/E 2

 

PVW

 

CLN

 

Cut

Fill

1

2

3

4

5

6

Figure 4-15.Output connections

„Use the following steps to connect the FSN-1400’s main Program outputs:

Note

All connections use BNC cables. All outputs are SDI (either SD-SDI or HD-SDI).

1.The Program Out 1 and Program Out 2 signals are identical. Connect to a monitor, and to your target destination device as required.

2.Connect Preview Out to a monitor. This output provides the Program bank’s “lookahead” preview video. In Chapter 7, refer to the “Understanding Lookahead Preview” section on page 319 for additional information.

3.Connect Clean Out to a monitor or the desired destination. This output provides the system’s main clean feed signal. In Chapter 2, refer to the “Clean Feed Output Selection” section on page 52 for details.

„Use the following steps to connect the FSN-1400’s M/E 1 outputs:

1.Connect M/E 1 Program Out to a monitor or the desired destination. This output provides M/E 1’s program output signal.

122

 

FSN Series • User’s Guide • Rev 01

 

Page 122
Image 122
Barco 26-0702000-00 manual lìíéìí=`çååÉÅíáçåë, Installation, FSN Series User’s Guide Rev