Barco 26-0702000-00 jìäíáîáÉïÉê=`~êÇ, 4 5 6, FSN-1400Orientation, 1 2 1, 1Ejectors, 3Loaded LED

2. FSN-1400 Orientation

Card Descriptions

jìäíáîáÉïÉê=`~êÇ

„Card status: Optional

„Installs in slot: 11

„Maximum number of cards per chassis: 1

The MVR (Multiviewer) is an optional card that provides the ability to display up to 16 source PIPs in both single and dual monitor configurations. With the desired monitor(s) connected to the card, users can set the MVR’s output resolution, and select from a variety of pre-defined multiviewer layouts.

The figure below illustrates the MVR’s front edge and rear panel connectors:

1

2

1

Multiviewer Card

MVR

Power Loaded

3

1 DigitalDVI

SDI

DigitalDVI

2 InputLTC

4

5

6

		Front Edge				Rear Panel
	Figure 2-13.MVR front edge and rear panel connectors
1)	Ejectors		3)	Loaded LED	5)	MVR Output 2
2)	Card Power LED		4)	MVR Output 1	6)	LTC Input

Following are descriptions of all MVR components:

1)Ejectors

Use the card’s top and bottom Ejectors to remove (and re-insert) the card.

2)Card Power LED

The Card Power LED indicates power status for the card. Refer to the “Card LEDs” section on page 64 for details.

3)Loaded LED

The Loaded LED indicates the status of all FPGAs on the card. Refer to the “Card LEDs” section on page 64 for details.

62 FSN Series • User’s Guide • Rev 01