Barco 26-0702000-00 manual ìñ=lìíéìí=`çååÉÅíáçåë, Installation, FSN Series • User’s Guide • Rev

4. Installation

Signal Connections

^ìñ=lìíéìí=`çååÉÅíáçåë

Aux (auxiliary) buses are extra switching buses that allow video signals to be routed from the FSN-1400 to external equipment. The figure below illustrates the Aux output connections on the M/E card’s rear panel, and the optional NAC and UOC rear panel:

PGM

PVW	DSK
CLN
PGM
M/E 1
PVW
CLN	AUX
PGM
M/E 2
PVW
CLN

Cut

Fill

1

2

3

4

5

6

Aux Out 1

Aux Out 2

Aux Out 3

Aux Out 4

Aux Out 5

Aux Out 6

SDI

1

2

3

4

5

6

7

8

NAC - installs in slots 11, 12, 13 Default: 13

Note:

Use the

Aux Setup Menu

to map

all NAC outputs

	UOC - installs in
	slots 11, 12, 13
1	Default: 12
Analog
DVI Digital
	Note:
	Use the
SDI	Aux Setup Menu
	to map
	all UOC outputs
	and set the
	output resolution
DVI Digital
Analog

2

Figure 4-16.Aux output connections

„Use the following steps to connect Aux outputs from the M/E, NAC(s) and UOC(s).

1.Using BNC cables, connect Aux Outputs 1 through 6 to your target auxiliary devices or monitors. These six outputs run at the system’s native resolution.

2.If one or more optional NACs are installed, use BNC cables to connect NAC outputs (as required) to your target devices or monitors. NAC outputs run at the system’s native resolution.

3.If one or more optional UOCs are installed, use BNC, DVI or HD-15 cables (as required) to connect outputs to your target devices. Use the Aux Setup Menu to set the output resolution for each UOC output. In Chapter 5, refer to the “Aux Setup Menu” section for setup details. In Appendix A, refer to the “UIC Input and UOC Output Formats” section for a list of available output formats.

Please note:

•Use the Aux Setup Menu to map NAC and UOC Aux outputs to the control panel, and name Aux outputs (if desired). In Chapter 5, refer to the “Aux Setup Menu” section on page 240 for setup details.

124 FSN Series • User’s Guide • Rev 01