bñíÉêå~ä=aph=fåéìí=`çååÉÅíáçåë

4. Installation

Signal Connections

bñíÉêå~ä=aph=fåéìí=`çååÉÅíáçåë

The figure below illustrates external DSK input connections on the M/E card’s rear panel:

Manual background PGM Manual background

PVW

DSK

 

CLN

 

PGM

 

M/E 1

 

PVW

 

CLN

AUX

 

PGM

 

M/E 2

 

PVW

 

Cut

Fill

1

2

3

4

5

External Cut In

External Fill In

CLN6

Figure 4-17.External DSK cut and fill connections

„Use the following steps to connect external DSK cut and fill signals to the M/E card. All connections use BNC cables.

1.Connect an external cut signal to the Cut connector. This type of signal typically originates from a character generator’s Cut or Key output.

2.Connect an external fill signal to the Fill connector. This type of signal typically originates from a character generator’s Fill or Video output.

Please note the following important points:

The DSK Cut and Fill inputs must be locked to the same video reference as the FSN-1400 chassis. SAV (start of active video) must be within +/- 0.5 lines of frame reference.

The DSK Cut and Fill signals must be set to the system’s native resolution.

Use the External DSK Setup Menu to set up the signals. In Chapter 5, refer to the “External DSK Setup Menu” section on page 229 for menu details.

In Chapter 6, refer to the “External DSK Input Setup” section on page 296 for step-by-step setup instructions.

FSN Series • User’s Guide • Rev 01

 

125

 

Page 125
Image 125
Barco 26-0702000-00 manual bñíÉêå~ä=aph=fåéìí=`çååÉÅíáçåë, Installation, FSN Series • User’s Guide • Rev