Barco 26-0702000-00 manual DVE Operations, DVE Menu Orientation, FSN Series • User’s Guide • Rev

8. DVE Operations

DVE Menu Orientation

•In the DVE Assignment Table, a flow chart of all keyers is provided. For each keyer, you can assign a DVE channel to the “cut” signal, to the “fill” signal, or to both — depending on your requirements. A button is provided for each signal.

To assign a DVE channel to a keyer:

•Press the desired keyer button in the DVE Assignment Table. The button is highlighted in yellow.

•Press the DVE channel that you want to dedicate to that Keyer. The name assigned appears in the chart.

Un-

Assign

Channel

Name

Channel

To un-assign a DVE channel:

•Press the desired keyer button in the DVE Assignment Table.

•Press {Un-Assign Channel}. The assignment clears.

DVE channels have default “system” names: DVE_9_1, DVE_9_2, DVE_10_1, and DVE_10_2. However, to custom-name a DVE channel:

•Press {Name Channel} to enter the naming mode.

•Press the desired channel button in the Rear I/O View.

•When the keyboard appears, enter the desired name (maximum eight characters) and press {ENTER}.

•When finished, press {Name Channel} to exit the mode.

DVE

Assign

Info

To get on-line information about DVE assignment, press {DVE Assign Info} to display the DVE Assignment Information Pop-up.

Note DVE Assign Information Close

To assign a DVE channel to a keyer, press a keyer button in the chart, then select the DVE channel to assign. Please note:

To “fly” a PIP or a luma key, one DVE channel is required. Assign a DVE channel to the desired keyer’s “Cut” signal.

To “fly” a linear key, two DVE channels are required. Assign DVE channels to the desired keyer’s “Cut” and “Fill” signals.

To “fly” a split key, either one or two DVE channels are required (depending on the effect you want to create). Assign channels to the desired keyer’s “Cut” and/or “Fill” signals.

To un-assign a DVE channel, press a keyer button in the chart, then press “Un-assign Channel.” Names are retained.

Figure 8-4.DVE Assignment Information Pop-up

Important

DVE assignments can be stored and recalled using the SYS category in the memory system. A specific “enable” button {DVE Assign} is provided on the Enables Menu. In Chapter 5, refer to the “System Enables” section for details.

364 FSN Series • User’s Guide • Rev 01