Barco 26-0702000-00 manual _ìííçå=j~ééáåÖ, Press Map Buttons to display the Map Buttons Menu

6. System Setup

Button Mapping

_ìííçå=j~ééáåÖ

	FSN Series system setup: Step 12
12	This procedure enables you to map inputs, sources, linear key cut and fill signals, test
	patterns, color background signals, and re-entry crosspoints to the panel.
		S Prerequisite — Ensure that you are familiar with the Map Buttons Menu. In
		Chapter 5, refer to the “Map Buttons Menu” section on page 224.
	„ Use the following steps to map buttons:
	1.	In the Menu Bar, press {System} to access the System Menu.
	2.	Press {Map Buttons} to display the Map Buttons Menu.
	3.	Use the {Panel Button} control to select the button you wish to map. Press
		{SHIFT} to map the button’s shifted position. The table changes accordingly.
	4.	To map an input (source) or a linear key “cut” signal to the selected button, press
		{Map Source/Cut}. The Map Buttons Keypad appears.
		~ To map a source, press {Source} to display sources only. Select the
		desired source and press {Map}.
		~ To map a test pattern, press {Test Patterns} to display internal test
		patterns only. Select the desired test pattern and press {Map}.
		~ To map a color background signal, press {Color BG} to display the four
		internal color backgrounds. Select the desired signal and press {Map}.
		~ To map an M/E program output (a re-entry crosspoint), press {Other} to
		display the two M/E program returns. Select the desired signal and
		press {Map}.
	5.	To map a linear key “fill” signal to the selected button, press {Map Linear Key
		Fill}. Follow the same procedure outlined in step 4.

Note

If you elect to use M/E 2, ensure that the M/E order is properly set using the Other Setup Menu. In Chapter 5, refer to the “Other Setup Menu” section on page 253 for details.

6.To clear a source from the panel, select the button you wish to clear, then press {Clear Source/Cut}.

7.To clear a linear key fill source from the panel, select the button you wish to clear, then press {Clear Linear Key Fill}.

Please note the following important points:

•When a source is mapped to a button on which another source is already mapped, the previous source is overwritten and un-assigned. On the Input Menu, the previous source's BNC turns yellow, but its name remains in the table.

FSN Series • User’s Guide • Rev 01 297